Directions: |
Directions:MAKE THE Q COMPANY’S BASIC RUB
Combine all the ingredients in an airtight container and shake vigorously until thoroughly mixed. You should have about 3 cups. (You can store the leftover rub in a dry, cool place for up to 6 months.)
MAKE THE Q COMPANY’S BASIC BBQ SAUCE
Combine all the ingredients in a medium nonreactive saucepan over low heat. Gently simmer, stirring occasionally, for at least 20 minutes. Set aside to cool to room temperature. You should have about 6 1/2 cups. (You may use the sauce immediately or store it in an airtight container in the refrigerator for up to 3 months.)
MAKE THE ST. LOUIS RIBS
Pat the ribs completely dry. Place the ribs, meaty side down, on your work surface. Use a butter knife or skewer to remove the silver skin on the underside of each rack of ribs. (The silver skin is the thick, shiny, opaque membrane that runs the length of the rack. To remove it, starting with the second bone, insert the knife or skewer between the membrane and the bone and rip or pull off the entire length of the silver skin, holding onto it with a paper towel because it gets slippery. Make sure the entire silver skin is removed, because it will keep the rub from flavoring the meat and it's tough to chew.) Repeat this procedure for each rack of ribs.
Coat the racks with 1 cup rub and massage the spices into the meat. You want to coat the ribs evenly. Add a generous drizzle olive oil to each rack and smear it over the ribs to sorta turn the rub into a paste. Store the ribs in a super large resealable plastic bag in the refrigerator for at least 6 hours and preferably overnight.
To cook the ribs in the smoker: Heat the smoker to between 225° and 240°F (107° and 115°C). Place the ribs, meaty side down, on the grill grate. Leave the ribs in this position for 1 hour. Then flip the ribs and cook for 1 hour more. Mop the top of the ribs with some of the barbecue sauce then flip the ribs meaty side up. Mop the meaty side of the ribs and cook for another 30 minutes or until each rack of ribs bends in the middle when it's picked up with tongs.
To cook the ribs on a gas grill: Put your soaked wood chips in an aluminum pie plate and cover the top tightly with aluminum foil. With a butter knife, poke about 10 holes in the foil. Remove the grates from one side of your grill and place the pie plate directly on those burners. Light your grill and set only the burners underneath the wood chips on their lowest setting. If there is a large vent on the side of the grill with the wood chips, plug it with an old rag to prevent the smoke from escaping. Keep your meat on the opposite side of the grill, where the grates are still in place. Wait for the wood to start smoking—at least 15 minutes—before you place your meat on the grill. Heat the grill to between 225° and 240°F (107° and 115°C). Place the ribs, meaty side down, on the grill grate. Leave the ribs in this position for 1 hour. Then flip the ribs and cook for 1 hour more. Mop the top of the ribs with some of the barbecue sauce then flip the ribs meaty side up. Mop the meaty side of the ribs and cook for another 30 minutes or until each rack of ribs bends in the middle when it's picked up with tongs.
Remove the ribs from the grill grate, brush them with more sauce, then cover with foil and let them rest for 20 to 30 minutes before serving. |
Personal
Notes: |
Personal
Notes: For a sweeter sauce, substitute honey for molasses in the recipe. For a sauce that packs more tingle, throw in some crushed red pepper flakes. For a smokier sauce, add ground ancho chile powder.
|
This recipe for St. Louis Ribs is from